In order to reset the check engine light for Your 2013 Ford Escape You will need to first need to turn the ignition in to the ON position but do not start the engine and at the same time You turn the ignition You will need to hold down both the brake and gas pedal. Hold down both of these pedals for 20 to 40 seconds and eventually You will see a reset notification pop up on Your navigation screen. It will run through this process for a moment and when it says complete You can let for of the pedals. This should now remove the light and You will be able to use Your vehicle as normal.
Shawn V.
April 9, 2020
The best way to do this is to undo the negative cable and then let it sit for a few minutes. This should cause a reset.
cecilt
April 29, 2022
How to reset check engine light on 2013 ford escape with PUSH BUTTON START on it
Earline B.
April 9, 2020
To reset the check engine light turn ignition to on position without starting the car and at the same time hold the brake and gas down firmly. Hold it for about 30 seconds and you will see it reset on the display in front of you. When it says the reset is complete, you can let up on the pedals and turn the key off.
I have just replaced the head on my escapeafter it had set for about a year, and it won'tstart and a enginefault service now message pops up on the screen whatcani do.
The Questions and Answers on this page are the statements and opinions of their respective authors and not VehicleHistory.com. VehicleHistory.com
does not research or authenticate any of the Answers provided.