The 2019 Toyota Highlander has an oil type of 0W-20 viscosity synthetic oil and has a capacity of 6.3 quarts. When performing an oil change on the car You will first want to make sure that the vehicle has been parked and off for a couple of hours. Otherwise, the oil in the car will be very hot and You could burn Yourself. Find the oil pan in the engine compartment and locate the drain plug on the underside. Position a bucket under the plug and then remove it. This will allow the oil to drain into the pan. Let it do this until it stops dripping, which may take an hour or so. After it has finished dripping You can put the drain plug back on, then locate the intake port on the top of the oil pan. Using a funnel fill the oil pan to full, but make sure to not overfill. A little under is fine, but going over can lead to leaks and oil burn off. Once it is full close the port up, wipe up any spilt oil and You will be finished.
Pat T.
January 2, 2020
The 2019 Toyota Highlander runs on a full synthetic oil type. Both the 4 -cylinder and V6 engines use SAE 0W-20. The 2.7L 4-cylinder's capacity is 4.4 quarts and the 3.5L V6 can hold 5.8 quarts
Capt T
December 6, 2021
SAE 0W-20 is the best choice for good fuel economy and good starting in cold weather. If SAE 0W-20 is not available SAE 5W-20 may be used. The 3.5 L V6 engine takes 5.8 qts, without the filter 5.6 qts.
Melody
January 5, 2024
How do you know if a shop used the correct vescosity oil in your oil change
The Questions and Answers on this page are the statements and opinions of their respective authors and not VehicleHistory.com. VehicleHistory.com
does not research or authenticate any of the Answers provided.